Terminal insertion machine may not be a very serious fault if it is not cut wire, but it will directly affect the production efficiency and production capacity. and through the query of the maintenance records of the fully automatic terminal machine is one of the effective processing means, and we should know the logic of solving the problem, form a set of our own processing method, and it is best to make a document to implement it.

Terminal insertion machine without wire cutting

Now most of the terminal insertion machines are equipped with fixed-length cut-off function, if it is found that the material is not cut, what on earth is going on?
The following JMK will do an analysis:

1. Whether it belongs to the setting problem.
If it is a automatic terminal insertion machine with cut-off function, but does not cut the material, then it will not be able to continue to work normally at all, which is a more serious problem, but do not worry, first check whether it belongs to the setting problem, and follow the testing principle of "soft before hard". Specific may need to refer to the "fully automatic terminal machine operating specifications tutorial" or the specific instructions. 

2. Peripheral fault. 
The non-cutting problems caused by the failure of the non-automatic terminal machine itself, such as insufficient air supply of the air compressor, may lead to inability to cut material, or even unable to do tangent action. Then it is necessary to check the gas supply capacity of the air compressor. The size of the air compressor used in the fully automatic terminal machine needs specific calculation. Not only that, we also need to be familiar with the requirements of more automatic terminal insertion machines for air compressors.

3. Fault of the machine itself.
Finally, check the hardware failure of the automatic terminal insertion machine itself, usually directly rely on the engineer's experience, check the maintenance history to solve the problem, but this is the fastest solution. In fact, this is also easy to understand, just like people, there may be some old problems, doctors look at the medical records, are likely to get important information. But in the end how to maintain, you can refer to "fully automatic terminal machine a-terminal fault repair", "fully automatic double-head terminal machine fault handling process".

In short, the automatic terminal insertion machine may not be a very serious fault, but it will directly affect the production efficiency and production capacity, so the problem needs to be solved as soon as possible. and through the automatic terminal machine maintenance record query is one of the effective processing means, and the specific logic to solve the problem in mind, to form a set of their own processing methods, and it is best to make a document to implement!